Denso AT21B-SM Manual de usuario descargar pdf (Pagina 57)

EAN-8 with add-on

A code ID mark precedes add-on code data under the conditions “Code ID mark: Type 4” and “Code ID mark

output mode: Separating.” (For details about the code ID mark, refer to (5) Code ID mark)

The conversion to the GTIN format is selectable. For the GTIN format conversion, refer to Section 9.5.

When the conversion to the GTIN format is disabled, the following formats apply.

With 2-digit add-on:

C/D X

With 5-digit add-on:

C/D X

: Prefix characters

5-9

: Add-on code data

CODE39

Code data read will be transmitted as is.

You can select whether or not to transmit start and stop codes (“ * ”).

Interleaved 2 of 5, Standard 2 of 5

The scanner transmits code data read, starting from the character following the start code to the one preceding

the stop code. No start/stop codes will be transmitted.

CODABAR (NW-7)

The scanner transmits code data read including the start/stop codes. You can select whether or not to transmit

start/stop codes.

CODE128, GS1-128 (EAN-128)

The scanner transmits code data read, starting from the character following the start code to the one preceding

the check digit. Start/stop codes, FNC codes, or check digit will not be transmitted. Note that FNC1 placed in

character positions other than the 1st and 2nd ones from the start code will be converted to GS (1Dh) and

transferred.

The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.

CODE93

The scanner transmits code data read, excluding start and stop codes and a check digit.

GS1 DataBar (RSS)

Code data read will be transmitted as is.

The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.

MSY, Plessey

The data, starting from the character after the start pattern, to the one before the stop pattern, are transmitted in

order.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 108 109

Sin comentarios

Denso AT21B-SM Manual de usuario Pagina 57