Denso AT21B-SM Manual de usuario descargar pdf (Pagina 29)

7.2 Data Editing

You can edit and output code data read, in any of the three data edit modes--“data extraction mode,” “data

conversion mode” and “blocksorting mode.” These data edit modes can be selected with the configuration

software (Scanner Setting). The default is “No editing.”

7.2.1 Data extraction mode

This mode offers three extraction choices--“data string,” “data block” and “AI (Application Identifier)-prefixed

string” extractions from code data read and then outputs it.

The “data block” extraction is available only when code data is in the comma-delimited CSV format.

The “AI-prefixed string” extraction is available for GS1-128 (EAN-128) and GS1 DataBar (RSS) symbols.

7.2.1.1 Extracting a data string

The scanner extracts a data string specified by the “Extraction start position” and “Extraction end position” from a

code specified by the “Code type” and then outputs it in the data transmission format selected in the scanner (see

Chapter 9, Section 9.4). The extraction conditions and extraction start and end positions are listed below.

 Extraction conditions

Extraction conditions Setting data

Any code

UPC-A/EAN-13

UPC-E

EAN-8

CODE128

GS1-128 (EAN-128)

CODABAR (NW-7)

CODE39

Interleaved 2 of 5(ITF)

Standard 2 of 5(STF)

CODE32

CODE93

MSI

Plessey

“Code type”

GS1 DataBar (RSS)

“Transmit data regardless of the results” Permit / Prohibit

If the scanner fails to extract a data string or scans a code not specified by “Code type” when the “Transmit data

regardless of the results” is permitted, then it outputs the data read as is without editing.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 108 109

Sin comentarios

Denso AT21B-SM Manual de usuario Pagina 29