Denso BHT-200QW Especificaciones descargar pdf (Pagina 80)

Chapter 2 Getting Started the BHT and System Menu

[2.3] ActiveSync (RF)

Choosing "3:ActiveSync (RF)" on the Communication menu connects the BHT to the host PC via the RF

interface port.

Before proceeding to "ActiveSync (RF)," you need to:

- Set up a partnership between the host PC and BHT by running "ActiveSync (IrDA)."

- Make the RF settings according to the procedure given in "[3.4] RF Menu (Network Control

Interface)." If the RF settings are not made correctly, "ActiveSync (RF)" cannot run.

When the BHT is opening the RF device and connecting to the

network, it displays the screen shown at left.

Connection to the network may take several tens of seconds

depending upon the network environment. (When the DHCP is

used for getting an IP address, connection to the network will

require more time than when the IP address is fixed.)

If connection to the network cannot be completed, the RF settings

may have not been made correctly. Check the RF settings again.

⇓

Upon completion of connection to the network, the screen shown at

left appears.

Select "Network Connection" as connection method and select the

name of the host PC in the Connect to box. Then tap the Connect

button.

⇓

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 165 166

Sin comentarios

Denso BHT-200QW Especificaciones Pagina 80