Denso RC5 Especificaciones descargar pdf (Pagina 69)

[ 2 ] Strobe Signal (Input)

(1) Function

This signal informs the Robot Controller that the command area, data areas

1 and 2, and the command and data area odd parity bit have been set.

Additionally it directs the start of command processing.

Caution: Perform command input with a strobe signal after the system

output signal ROBOT INITIALIZATION COMPLETE is output.

(2) Terminal number

No. 8 of connector CN8.

(3) Input conditions and operation

 By turning ON this input in automatic or external mode, the Robot

Controller reads the command area, data areas 1 and 2, and the

command and data area odd parity bit starts processing.

 Retain the status until a command processing complete signal is output

and the necessary status data is read. If the strobe signal is turned OFF

before a command processing complete signal is output, the status area

will not be output.

 By turning OFF this input after the status is read, the command

processing complete output, the status area and the status parity will be

turned OFF.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 181 182

Sin comentarios

Denso RC5 Especificaciones Pagina 69