Denso Power Net Terminal BHT-103 Manual de usuario descargar pdf (Pagina 88)

BHT-700BB-CE/700BWB-CE/700BWBG-CE

[4] ActiveSync(RF)

Tap “4:ActiveSync(RF)” at the Communication menu to connect to the host computer by wireless

communication.

− Point −  Before running “ActiveSync(RF)”, it is necessary to set up a partnership between the host

computer and BHT by running "ActiveSync (Infrared)" or "ActiveSync (USB)".

 It will not be possible to run “ActiveSync(RF)” if the wireless settings are incorrect.

Refer to “4.4.3 System Properties” – “[8] Radio Frequency Menu (NIC Control)”, or “4.5

Wireless Network Settings” before making wireless settings.

 ActiveSync(RF) cannot be used with ActiveSync 4.X. Use ActiveSync 3.8 or earlie

version.

1. Open the wireless device.

The screen on the right displays when a connection to the network has

been established.

− Note −  Connecting to the network may take several tens o

seconds depending upon the network environment.

(When the DHCP is used to obtain an IP address,

connecting to the network will require more time than

when the IP address is fixed.)

 If unable to establish a connection to the network, the

wireless settings may be incorrect. Check the wireless

settings again.

2. Select "Network Connection" for the connection method, specify

the name of the host computer in the "Connect to" field, and tap the

[Connect] button.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 175 176

Sin comentarios

Denso Power Net Terminal BHT-103 Manual de usuario Pagina 88