Denso GT10B-SB Manual de usuario descargar pdf (Pagina 41)

7.2 Specifying the Numbers of Digits of Standard 2of5 and Interleaved 2of5 Symbols to

Read, by Scanning Bar Codes

You can specify the numbers of digits of Standard 2of5 and Interleaved 2of5 symbols to read.

First enable the parameter "specification of the number of digits by bar code scanning" by using the bar-coded

parameter menu or configuration software. Then scan Standard 2of5 or Interleaved 2of5 symbols. The numbers of

digits of symbols scanned first and second (after you enable the parameter or turn the scanner on) will be registered in

the memory.

After the registration, the scanner can read only Standard 2of5 or Interleaved 2of5 symbols having either of those

specified numbers of digits.

(Example)

123457

1234567895

Specifying the number of digits readable

First scan: 6-digit Interleaved 2of5 symbol

 Just the bar code type and the number of digits will be stored in the scanner.

The code data will be sent.

Second scan: 10-digit Interleaved 2of5 symbol

 Just the bar code type and the number of digits will be stored in the scanner.

The code data will be sent.

After that, 6-digit and 10-digit Interleaved 2of5 symbols only can be read.

987653

98765430

Scanning after setting the number of digits readable

6-digit Interleaved 2of5 bar code

 This bar code can be read.

8-digit Interleaved 2of5 bar code

 This bar code cannot be read.

Note: Any of the following events clears the number of digits specified above.

- Scanning the "Start operation" or "End operation" bar code with the scanner.

- Customizing the scanner by modifying the parameters with the configuration software (ScannerSetting),

bar-coded parameter menu, or batch-process bar code symbols.

- The scanner power is turned off due to the removal/replacement of the battery cartridge or the low battery.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 143 144

Sin comentarios

Denso GT10B-SB Manual de usuario Pagina 41